Potential Dash Knob Project

Mark has found someone that may be able to do 3-d printing of the dash knobs. They are making up a set now and we'll see how they come out. I think a number of people can use them?

Aug 16, 201559 views

Replies (2)

· Jan 13, 2017

I measured up my 8 -31 Victoria and the cables lengths are different than on the 8 -35 . My L knob is attached to a light switch , S requires 40 inches - H requires 40 inches - C requires 48 inches they all require armoured cable roughly this length with the interior wire sticking out a few inches past the armoured cable . I will trim them to fit when I install the cables . Greg Coleman is casting them directly into the knobs except the L knob which has a 6 - 32 thread tapped into the knob to accept the light switch .

· Feb 13

Here are what the finished knobs look like.

To join in the conversation, you must be a club member.

You’re welcome to read and like every post. Members can reply and start topics of their own.